Automatic precision adjustment resistor machine

User:resistor Machine Features:Auto-adjusting resistors Working Range:X Axis 400mm, Y Axis 400mm,Z Axis 100mm, U Axis 400mm,V Axis 300mm Product size range:Product size range is approximately less than and equal to 120mm（L)*120mm(W) Machine Overall Positioning Accuracy :3μm Max Speed:300mm/s Measuring Repeatability(Static):5μm Machine Overall Size:1000*1000*2000mm

Technical Parameters

Technical Specification

Automatic precision adjustment resistor machine
机台名称	环形导轨多功能自动化光学检测设备
User	resistor
Machine Features	Auto-adjusting resistors
Machine Overall Size	100010002000mm
Weight	750KGS
Working Range	X Axis 400mm, Y Axis 400mm,Z Axis 100mm, U Axis 400mm,V Axis 300mm
Positioning Way	Fixture positioning
Operation Way	Manual loading，Auto-adjusting resistors
Product size range	Product size range is approximately less than and equal to 120mm（L)*120mm(W)
Machine Overall Positioning Accuracy	3μm
Max acceleration	200/ms
Adjusting resistance time	Detection time varies depending on the size and material of the measured product and the point data. The actual testing time shall prevail.
Measuring Repeatability(Static)	5μm
Main Configuration	a.Marble platform + upper and lower frame + XYZUV KK module set + product fixture b.one set of computer hardware + one set of EDAC synchronous motion acquisition card C.EDAC self-developed 802 inspection software.
Ambient Environment	a. Temperature: 22°C±2°C b.Humidity:55-65% c. Vibration: The floor vibration of the installation site, when the vibration is below 10Hz, the amplitude must be below 2μP-P. When the vibration is between 10Hz~50Hz, the acceleration must be below 0.4qal. It is recommended that the installation place is as far away as possible from vibration sources such as press machines or large truck passages to ensure the accuracy of the machine; d.Power supply: 1.220V AC, 50HZ; 2. Power: <1000W ; 3. The power socket is a triangle plug; 4. The power supply needs to be grounded; e.Air source (when a vacuum system is required): 1. Compressed air greater than 6 kg, the air needs to be dried and filtered. There is no model requirement for the model of the dryer and filter, just ensure that the filtration density is less than 1μ; 2. Ensure stable air pressure; 3. Ensure that the consumed air flow is greater than 630L/min; f. Product discharge connection (the following method can be used if necessary Do connection): Both OK and NG products require manual pickup
＊　As different materials &surface processing could affect the accuracy that can be achieved, and the practical accuracy is decided by the final measuring result.